Week 14 : Making a Final Year Project 1 Report

After the Presentation Day last week, my supervisor Madam Norhayati required me to do and send the report regarding of my project. The report consist of Abstract, Chapter 1 (Introduction), Chapter 2 (Literature Review),Chapter 3 (Methodology) , Reference and Appendix. For the abstract, I had already previously on week 7. The content of Chapter 1 was an introduction about the project. Next, for Chapter 2 is all about the previous research that has been done regarding the project, for example, the method that was used to build the project. Lastly, the methodology is about the explanation of method that was used to do the project, the time schedule of the project and also the estimated cost to do the project. The due date to submit the report was on week 17.

Week 13 : Presentation Day (Final Year Project 1)

On 17^th October 2018 become a big day for Final Year Project 1 student, after all the research that had been made for the proposed project. It is time for the Project Proposal Presentation Day for Final Year Project 1. The event held at Dewan Gemilang Unikl Bmi, it start at 2.30 p.m until 5.00 p.m. Next, each student were given 2 different assessor, me myself got Kamalulfaizin Bin Mohd Suhut and Hazizulden Bin Abdul Aziz .

Here i attached the Power Point Slide Presentation that i had done:

• Development of an Inteligent Solar Powered Planr Watering System

Week 12 : Preparing the Slide Presentation

For this week, all Final Year Project 1 student need to make a slide presentation for upcoming Project Proposal presentation day. The student need to follow the guideline that was given by the final year project committee during the briefing before. I also meet with my supervisor, to show the slide presentation that i had done. It seems that i need to fix the block diagram and the flowchart part of the slide. The rest is good according to her.

Week 11 : Research and Finding

 Flow Chart

On tops of shows the flow chart of this project. Firstly a soil moisture will be detect level of moisture which it dry or wet, while temperature and humidity  sensor will detect the amount encompassing temperature either high or low.  If the wetness sensing element result's dry and therefore the temperature sensing element is high, the sensing element can send data to Arduino, and it'll trigger to fertiliser valve and water valve. The fertilizer and water will  be watering into the plant until the soil is wet and obtain enough fertilized.